Hi all,
Some of my applications occasionally report false positive blips. I am not quite sure yet why it happens, presumable some network latency, heavy VBScripting or whatever... anyway - it doesn't happen often. But when it does - it creates a bit of a panic as it flashes RED straight away and fires of alerts.
Is it possible to configure some kind of "double check" after a few seconds before application reports status as DOWN due to not being able to reach host or run script or whatever?
P.S.
1. I know it is possible to DELAY alert, however - this would not work for dashboard status
2. I know it is possible to configure threshold based on number of failures - but this is only applicable for CRITICAL/WARNING states, not for DOWN state
Any suggestions/help is welcome
--
Alex